Instruction Manual

Regency U31-3 Gas Fireplace Insert
2525
INSTALLATION
OPERATING INSTRUCTIONS
COPY OF LIGHTING INSTRUCTION PLATE
SHUTDOWN
PROCEDURE
1) Use the rocker switch to turn off the
main burner.
2) Open the bottom louver assembly.
3) Push in the gas control knob slightly
and turn clockwise to "OFF". Do not
force.
4) Disconnect all electric power and
gas to the appliance if service is to
be performed.
FIRST FIRE
The fi rst fi re in your stove is part of the
paint curing process. To ensure that the
paint is properly cured, it is recommended
that you burn your fi replace for at least
four (4) hours the fi rst time you use it
with the fan on. When fi rst operated,
the unit will release an odour caused by
the curing of the paint, the burning off of
any oils remaining from manufacturing.
Smoke detectors in the house may go
off at this time. Open a few windows to
ventilate the room for a couple of hours.
The glass panel may require cleaning
after the unit has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Note: When the glass is cold and
the appliance is lit, it may
cause condensation and fog
the glass. This condensation
is normal and will disappear
in a few minutes as the glass
heats up.
DO NOT BURN THE APPLI-
ANCE WITHOUT THE GLASS
FRONT IN PLACE.
NORMAL OPERATING SOUNDS OF
GAS APPLIANCES
when ON. This sound will increase or decrease
in volume depending on the speed setting of
your fan speed control.
Burner Tray:
The burner tray is positioned directly under the
burner tube(s) and logs and is made of a differ-
ent gauge material from the rest of the fi rebox
and body. Therefore, the varying thicknesses of
steel will expand and contract at slightly different
rates which can cause "ticking" and "cracking"
sounds. You should also be aware that as there
AUTOMATIC
CONVECTION
FAN OPERATION
The fan operates automatically, turn the knob
on the side of the faceplate to adjust to the
desired speed. The fan will turn on as the stove
comes up to operating temperature. After the
unit has been turned off and the unit cooled to
below a useful heat output range the fan will
shut off automatically.
It is possible that you will hear some sounds
from your gas appliance. This is perfectly
normal due to the fact that there are various
gauges and types of steel used within your
appliance. Listed below are some examples.
All are normal operating sounds and should
not be considered as defects in your appliance.
Blower:
FPI gas appliances use high tech blowers to
push heated air farther into the room. It is not
unusual for the fan to make a "whirring" sound
OFF
a