Installation manual

16
F5100 Regency Freestanding Woodstove
INSTALLATION
The Outside Air Kit is an option for Freestanding Stoves. Outside air for combustion can be brought in either through the bottom of the pedestal or
bottom heat shield or through the rear plate of the pedestal.
For both bottom and rear outside air the Pedestal Cover Plate must be installed. Loosen the 4 screws on the rear of the pedestal and slide the cover
plate over them. Slide the plate to the left to center it and tighten down the 4 screws.
Rear View
Completed Install
Side View
Outside Air Through Pedestal Bottom
Mark the position of your unit as outlined in the "General Information"
and "Clearances to Combustibles" section of the manual. Pipe fresh
air into the pedestal area by using a minimum 4" duct pipe with a
mesh grill at the outside termination.
Outside Air Through Pedestal Rear
Remove the blanking plate from the rear of the pedestal and bend
the two tabs out 90 degrees. Pipe fresh air into the pedestal area
by using a minimum 4" metallic duct pipe with a mesh grill at the
outside termination.
Fasten the pipe to the cover plate using the tabs and 2 screws.
Damper Installation
NOTE: The damper cannot be installed if attaching outside air to the
bottom of the appliance.
Supplied damper allows the combustion air to be closed off when unit
is not in operation.
Install the damper within the round pipe in an easily accessible location.
1. Drill a 5/16" hole in the desired location.
2. Insert damper with threaded section out.
3. Install damper handle and secure with wing nut.
Wing nut
Damper handle
Damper
OPTIONAL OUTSIDE AIR KIT