Instructions / Assembly

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

TVCTRC14452, TVCTRC19252, TVCTRC24052, TVCTRC28852 - INSTRUCTIONS

You will need 2 or more person(s) for this assembly.

You will need a Hex Head and Phillips Head Screw Driver.

Hardware : PART & HARDWARE QUANTITIES WILL VARY DUE TO THE TABLE SIZE.

A: Bolt • B: Lag Screw

Parts :

C: End Piece • D: Center Piece • E: Inside Stringer • F: Outside Stringer • G: Center Leg • H: End Leg

NOTE: Center Leg(G) has cutout for Power Data Grommet.

STEP 1 : Attach the Inside Stringer(E) and 2 Outside

Stringers(F) to one End Leg(H) using 6 Bolts(A).

STEP 2A : Attach the Center Leg(G) to the 2 Outside

Stringers(F) and Inside Stringer(E) using 6 Bolts(A).

STEP 2B : Continue STEPS 1-2A for all Legs and Stringers.

PAGE 1
TVCTRC14452, TVCTRC19252, TVCTRC24052, TVCTRC28852 - INSTRUCTIONS You will need 2 or more person(s) for this assembly. You will need a Hex Head and Phillips Head Screw Driver. Hardware : PART & HARDWARE QUANTITIES WILL VARY DUE TO THE TABLE SIZE. A: Bolt • B: Lag Screw A B Parts : C: End Piece • D: Center Piece • E: Inside Stringer • F: Outside Stringer • G: Center Leg • H: End Leg NOTE: Center Leg(G) has cutout for Power Data Grommet.
PAGE 2
TVCTRC14452, TVCTRC19252, TVCTRC24052, TVCTRC28852 - INSTRUCTIONS STEP 3A : Attach the Center Piece(D) to the 2 Outside Stringers(F) and Center Leg(G) using 4 Bolts(A) and 4 Lag Screws(B). See Figure 1. F D D B G A G A Figure 1 STEP 3B (if installing additional Center Pieces) : Slide additional Center Pieces into place. Figure 2. Then, repeat STEP 3A until all Center Pieces are installed. Figure 2 STEP 3A : Slide End Piece(C) into Center Piece(D) (Figure 2 above).
PAGE 3
TVCTRC14452, TVCTRC19252, TVCTRC24052, TVCTRC28852 - INSTRUCTIONS STEP 4 : Tighten all sash locks on all Top Piece connections. See Figure 3.