Instructions / Assembly

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

LWD6524- INSTRUCTIONS

You will need a Phillips Head screwdriver and a rubber mallet to assemble.

Hardware :

A: Locking shelf pins(4) • B: Pole Support(2) • C: Hinges(3) • D: Brackets(3) • E: Shelf Pins(4)

F: Long Screws(2) • G: Cam pins(19) • H: Adjustable Glides(4) • I: Cam lock covers(19)

J: Hole Covers(3) • K: Small Screws(34) • L: Handle • M: Pole • N: Door stopper(2) • O: feet(4)

B C D E F G H I J K L M N O

Parts :

P: Front Runner • Q: Adjustable shelf • R: Fixed shelf • S: Door • T: Top • U: Left side • V: Right Side

W: Back • X: Bottom Y: Support Shelf

T U V W X

STEP 1 : Lay Back(W) down with cam locks facing

up and screw in one cam pin(G). Connect bottom(X)

to back(W) by inserting the cam pin on the back into

the lock on the bottom and Tighten(See Fig 1). Be sure

the cam locks on the bottom are facing away from

the back.

STEP 2 : Attach 3 brackets(D) with 2 screws(K)

each to the right side(V) and 7 cam pins(G) to each

side(U&V).

Fig 1

PAGE 1
LWD6524- INSTRUCTIONS You will need a Phillips Head screwdriver and a rubber mallet to assemble.
PAGE 2
LWD6524- INSTRUCTIONS You will need a Phillips Head screwdriver and a rubber mallet to assemble. STEP 3 : Attach right side(V) to back(W) and bottom(X) by inserting cam pins into locks. Do not tighten locks until instructed. STEP 4 : Attach support shelf(Y) to the back(W) and right side(V) with cam locks facing the bottom. Also attach front runner(P) to the bottom(X) and right side(V). Then tighten all cam locks from this step and from step 3.
PAGE 3
LWD6524- INSTRUCTIONS You will need a Phillips Head screwdriver and a rubber mallet to assemble. STEP 9 : Attach 3 hinges(C) to door(S) with 2 screws(K) each hinge. Do not screw hinge into position until perpendicular with the ground. C STEP 10 : Attach door(S) to unit by inserting the protruding screw (2a) from the brackets(D) into the open end of the hinges(C) and tightening. The screw that is located on the hinges(C) (3a) is used for alignment of the door(S).