Instructions / Assembly

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

LWD6524- INSTRUCTIONS

You will need a Phillips Head screwdriver and a rubber mallet to assemble.

STEP 9 : Attach 3 hinges(C) to door(S) with 2

screws(K) each hinge. Do not screw hinge into posi-

tion until perpendicular with the ground.

STEP 11 : Use the 2 long screws(F) to attach the

handle(L) to the door(S) by inserting the screws

through the back of the pre drilled holes in the

door(S) and tightening the handle to the front of the

door as the photo shows below.

OPTIONAL STEP

STEP 13 : Use 3 small screws(K) to attach the

pole supports(B) to the sides. There is a pre drilled

hole on each side(U,V) that lines up the bottom

screw(K) of the pole support(B). Screw that screw

in rst to ensure a level pole, then screw the top 2

screws in place and insert pole(M).

STEP 10 : Attach door(S) to unit by inserting the

protruding screw (2a) from the brackets(D) into the

open end of the hinges(C) and tightening. The screw

that is located on the hinges(C) (3a) is used for align-

ment of the door(S).

STEP 12 : Find where the long screw(F) on the

back of the door(S) touches the left side(U) and

place the 2 door stoppers(N) in between the two.