Owner`s manual

BLADE ATTACHMENT

1. Place washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeat this

procedure without tightening the screw until all screws have been started into the blade arm. (Fig. 4).

2. Tighten all screws. Repeat for remaining blade arms/blades.

3 Fasten blade assembly to motor with screws and washers provided. Repeat procedure for remaining blades

(Fig. 5). Make sure screws are TIGHT! Loose motor screws can contribute to unneccessary hum during

operation.

BLADE ATTACHMENT:

Fig. 4

Fig. 5