Installation manual

Regency Plateau™ PTO30 Outdoor Gas Fireplace

INSTALLATION

NOTE: If using framing unit with original version of PTO30 (not -1), cut

base in areas shown below and fold down to allow room for the

larger size.

1. Attach six (6) short vertical supports (Part C) to base (Part D) with

two (2) screws for each support - twelve (12) screws total. Do not

install corner screws.

2. Rest subassembly and inner tall vertical supports (Part B) on lower

frame (Part A).

3. Attach inside tall vertical supports (Part B) to short vertical supports

(Part C) with one (1) screw each.

4. Secure all vertical supports (Part B) with two (2) screws each to

lower frame (Part A).

5. Place top frame (Part A) on inside tall vertical supports (Part B).

6. Secure in place with two (2) screws for each support

7. Manoeuvre in outside tall vertical supports (Part B).

Part B

Part C

Part A

Part B

Part C

Part D

Diagram 1

Cut

Fold

Diagram 2 - Base Subassembly

Diagram 3

Diagram 4

Part A

Diagram 5 - Top Frame

Part B

Diagram 6 - Outside Part B