Installation manual

17
Regency Horizon™ HZO42 Gas Fireplace
INSTALLATION
INNER PANEL INSTALLATION
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels
• Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
• Use a hair dryer or similar device to remove the protective coating from the panels.
• Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
1) Install the back panel fi rst - to maneuver the panel into position - tilt
the top of the panel forward and position the bottom of the panel
in fi rst. Use care - do not scratch the panel when clearing the pilot
hood.
2) Install a side panel next (not important which side goes in fi rst).
Position the panel with the bend in the panel facing towards the
outside or wall of the unit. Position side panel and secure with a clip
and one screw.
3) Install other side panel next. Position side panel and secure with a
clip and one screw.
4) Final install - shown below.