Instructions / Assembly

IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
A
B
C
D
E
F
G
A. Table Top
B. Large Base
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
Round Table Top INSTRUCTIONS
(MTBX22, MTBX30, MTBX36, TTRD30, TTRD36, TTRD42, TTRD48)
Step 1: Screw 4 feet (F) into
base (B) leg ends.
Step 2: Remove the nut from rod
(E) and set aside.
Step 3: Insert the rod(E) through
the hole in the base (B) and attach
nut to exposed rod end under
base bottom .
STEP 4: Next place the cylinder
(C) over the exposed metal rod (E).
STEP 5: Place the exposed end of
the metal rod
(E) through the hole
in the spider (D) and twist the sec-
ond nut back onto the rod until
tight
STEP 6: Turn table upside
down. Draw a line across the
table at the widest point up and
down and again left and right to
find
center.
The product
should now
look like the
example to the
right.
STEP 7: Place dot 1, located on
the back of this instruction, directly
over the crossing lines on the table
top (A).
STEP 8: Once aligned, punch a
pen through remaining
template dots 2,3,4,5 and mark
table bottom.
1
2
11
3
4
5
Organize your parts. You will need a drill, crescent wrench and pencil. Two people are required for assembly.
STEP 10: Line Up the marks
made on table from step 8 with
the holes on the spider arms.
STEP 11: Screw in all 8 screws
(G) and flip table over.
STEP 9: Place
table top
(A) flat
on the floor and
set the
completed base
(H) over the cen-
ter.
H
1
2
3
4
5
2
3
4
5
1
1