Operation Manual

23
Mounng
Before beginning the installaon process, read the REL Setup Made Simple secon for instrucons about
how to select the best locaon for Habitat1.
The following step by step instrucons guide a Habitat1 user in mounng the cabinet to a typical home wall
made of studs with drywall nish or brick masonry walls. The Habitat1 must be securely anchored to the wall.
There are two sets of mounng brackets for the Habitat1 cabinet. Each set is made up of a wall side bracket
and a cabinet side bracket that are designed to t together to create a solid mounng for the Habitat1.
Stud Wall Mounng
The top bracket spans most of the length of the cabinet and should get mounted to two studs that are
400mm (16 inches) apart. If the studs in your wall are farther apart, please contact your dealer for a longer
bracket to span up to 457mm (18 inches). The boom bracket is shorter and should get anchored to one
stud and a sturdy drywall mount. Both brackets are required for the Habitat1 to funcon properly. Two
people are recommended for proper installaon.
Supplied Hardware:
- Bracket A (long wall bracket) - Bracket B (long cabinet bracket)
- Bracket C (short wall bracket) - Bracket D (short cabinet bracket)
- Gasket long - Gasket short
- Self drilling #8 drywall anchor - Wall mount template
- Flat head screw M6 thread, 4mm hex drive, 21mm length (x5)
- Socket cap screw M6 thread, 5mm hex drive, 13.5mm length (x3)
- Socket cap screw M6 thread, 5mm hex drive, 50mm length (x2)
Bracket B
Bracket A
Long gasket
Bracket C
Bracket D
Short gasket
50mm (x5)
13.5mm (x5)
21mm (x5)