Operation Manual
29
21 Install Grille.
Now that the Habitat1 sub woofer is mounted to the wall, it is me to revisit the sengs to really dial in
the system.
Crossover and Level Sengs: To determine the crossover point, take the volume of the REL (using the HI/
LOW Level control) all the way down, and put the crossover to 25 Hz. At this point bring the REL’s volume
back up slowly to the point where you have achieved a subtle balance, i.e. the point at which you can hear
the REL even with the main speakers playing. Now, bring the crossover point up unl it is obviously too high;
at this point bring it down to the appropriate lower seng. For all intents and purposes, this is the correct
crossover point. Once this stage has been reached, subtle changes to volume and crossover can be made to
provide the last bit of complete and seamless integraon.
Hint: There may be a tendency to set the crossover point too high and the volume of the Sub-Bass system
too low when rst learning how to integrate a REL with the system, the fear being one of overwhelming the
main speakers with bass. But in doing so, the resulng set-up will be lacking in bass depth and dynamics.
The proper crossover point and volume seng will increase overall dynamics, allow for extended bass
frequencies, and improve soundstage properes. Note that volume must be adjusted in conjuncon with
crossover changes. In general, when selecng a lower crossover point, more volume may need to be applied.