Operation Manual

31
Required (not supplied):
- Philips screwdriver - Pencil
- Drill / driver - 14 inch ruler or tape measure bit
- 5/16 masonry drill - 3/16 masonry drill
- 4mm hex driver - 5mm hex driver
- Glue -Medium adhesion painter’s tape
- Hammer - Size 8 Masonry anchors (X4)
- Level - 1 5/8 ne thread drywall screws (x2)
(This is a suggested length. Your wall may require longer screws)
1 Remove grille and set aside on a clean surface.
2 Mount cabinet side brackets (brackets B and D) to the cabinet using at head screws. This step should
have been completed in the REL Setup Made Simple secon.
3 Determine placement of the Habitat1. See the REL Setup Made Simple secon of this manual.
4 Holding the cabinet in place on the wall, mark the wall along the top edge of the top bracket and at the
right corner.