Operation Manual

34
13 With top wall bracket (bracket A) in place, use the supplied wall mount template to locate the holes
for bracket C. This template should work for all solid walls. Place template directly under bracket A and
mark the holes indicated for your wall construcon. The top of bracket C should be 323mm (12.7 inches)
is below the top of bracket A.
14 Drill a pilot hole for the two screw holes using the drill / diver and 3/16 drill bit.
15 Drill hole for anchors using the drill / driver and 5/16 drill bit.
16 Put glue on masonry anchors before installing. Push masonry anchor into wall and drive ush with hammer.
17 Place short gasket on the back side bracket A. Gasket must go between wall and bracket. Do not omit
the use of this gasket.
18 Screw boom bracket to wall using screws. Make sure screws are ght and bracket is mounted securely
to wall.