User's Manual

fonctionne pas normalement , ou a été échappé .
15 10cm distance minimale autour de l'appareil pour une aération suffisante;
16 il convient que l'aération ne soit pas gênée par l'obstruction des ouvertures d'aération par des objets tels
que journaux, nappes, rideaux, etc.;
17 il convient de ne pas placer sur l'appareil de sources de flammes nues, telles que des bougies allumées;
18 il convient d'attirer l'attention sur les problèmes d'environnement dus à la mise au déchet des piles;
19 si l'appareil est destiné à être utilisé sous un climat tempéré.
Attention: Tout changement ou modification non expressément approuvés par la partie responsable
de la conformité pourraient annuler l'autorité de l'utilisateur à utiliser cet équipement.
Sécurité Design
Cet appareil est livré avec un cordon amovible cordon . . Pour le fonctionnement d'un fusible de 230V 7A
est montée dans la douille , pour le fonctionnement de 120V un fusible de 15A est monté. Si le fusible doit
être remplacé utilisation un fusible similaire approuvé pour ASTA ou BSI normes 362 . Ne pas utiliser sans
le couvercle de fusible en place . Les couvercles de rechange sont disponibles auprès de votre distributeur
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital Device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
PAGE BREAK
Dear Friend and Valued Customer,[major heading]
Thank you for purchasing your new REL No.25, this unit is produced with great pride and
operates as the standard bearer summarizing a journey that has taken REL 25 years to achieve. As
the commemorative unit marking 25 successful years, the No.25 takes all the best technologies
developed over the past quarter century and adds a few important design improvements to create
a new standard to carry us on to the next 25 years.