Operation Manual

9
• The standard HIGHLEVEL hook up procedure is: aach the red wire to the amplifier’s right posive
speaker output terminal; aach the yellow wire to the amplifier’s le posive speaker output terminal;
aach the black wire to whichever of the amplifier’s ground output terminals is convenient; plug the
Speakon connector into the Sub-Bass System’s HIGHLEVEL input.
• For differenal (i.e. fully balanced) amplifiers using one REL, simply use the standard connecng scheme
with the excepon of connecng the black wire to chassis ground (i.e. a metal bolt or screw, preferably
not painted or anodized, on the chassis of the power amp or receiver), not to a negave speaker terminal,
and then connecng into the HIGH-LEVEL input on the REL. Please contact your dealer should there be
any quesons concerning this or any other hookup procedure.
NOTE: The Serie T models are equipped with internal circuitry to allow seamless connec"on to Class-D
(digital) main amplifiers. If connec"ng to a Class-D amplifier, follow the above connec"on procedure for
differen"al amplifiers.
+ L – + R –
Amplifier Main Speaker Outputs
Yellow
Black
Red
Supplied Neutrik Speakon HIGH-LEVEL Interconnect
HIGH-LEVEL Input Release Lever
+ L – + R –
Yellow
Red
Black
Chassis Screw
Supplied Neutrik Speakon HIGH-LEVEL Interconnect
+
Amplifier Main Speaker Outputs