User Manual

1 Volume Control for HI/LOW Level input: Use to adjust output when using either HI Level or LOW Level

input. Do not use both simultaneously.

2 Volume Control for .1/LFE Input: Use to adjust output level when using .1/LFE input from a 5.1 amplier

or processor.

3 Crossover: Used to select crossover frequency. Variable between 30 Hz and 120 Hz.

4 Low-Level Le channel Phono Input: Used to connect low-level to the output of a preamplier,

integrated amplier or receiver. (For home cinema, use .1/LFE input).

5 Low-Level Right channel Phono Input: Used to connect low-level to the output of a preamplier,

integrated amplier or receiver. (For home cinema, use .1/LFE input).

6 .1/LFE Phono Input: Used to connect to the .1/LFE output from a 5.1 amplier of processor.

7 Phase: Used to set phase 0-180 degrees.

8 High-Level Neutrik® Speakon® Socket: Use to connect high-level to the main front amplier

speaker terminals.

9 Wireless enable switch: Used to turn on wireless receiver when connected to REL Longbow™

wireless transmier.

10 Standby/Always On Switch: Used to enable standby mode.

11 Power Pilot Light: Power On/O indicator.

12 Power ON/OFF Switch: Use to turn unit on or o.

13 IEC Mains Socket: Fused mains (AC) input socket that accepts a detachable power cord.

14 Antenna connector: Used with REL Longbow™ wireless transmier.

15 Pair Pilot Light: Indicates if unit has been paired with REL Longbow™ transmier.

16 Pair Switch: Used to iniate Pair sequence with REL Longbow™ Transmier.

REL 212/SE Rear Panel Connecon Legend