User Manual
The REL HT-Air™ Wireless is intended to be used with the
SerieHT or similar REL sub bass system. The transmier and
receiver will require power from an AC wall plug using the
power adapter cable supplied.
It is not possible to use the HT-Air™ Wireless connecon
and a direct connecon simultaneously. Using both wired
and wireless connecons simultaneously could result in
damage and voids all warranes.
Always switch your system o before disconnecng any wires.
With the REL SerieHT, there are two basic ways to connect
and setup. The rst is a single channel input from the sub
out of a theater or power speaker system. In this case a
single RCA cable is need and the CROSSOVER control can
be set to LFE since the source will have an internal upper
frequency limit.
Connecng Up