User Manual

Now that the HT-Air™ Wireless transmier and receiver are
connected to your system, the unit will need to be paired.
1 Make sure that the transmier AC to DC wall plug supply
is connected to an AC outlet, and that the barrel connector
is connected to the transmier.
2 Make sure that the receiver AC to DC wall plug supply is
connected to an AC outlet, and that the barrel connector
is connected to the receiver.
3 Make sure that the sub is plugged into an AC outlet using
the supplied AC cable and that the sub is turned on.
Power switch is located on the rear panel.
4 At this point the transmier and receiver should nd
each other and pair together. This will be indicated by
the “Pair” LEDs on both the transmier and control
panel staying lit (no ashing).
5 In the event that the transmier and receiver do not
automacally pair, simply exercise the momentary “Pair”
buon on the receiver unl the LED ashes.
6 Then exercise the “Pair’ buon on the transmier.
Pairing