Operation Manual

REL Acoustics ‘ST III’ User Manual
15
To connect to the amplifier/processor using the phono to phono low
level interconnect
Two low level inputs are provided, 0dB and +12dB,
Connect as shown above using a phono to phono interconnect (not supplied). Plug one end
into the sub/LFE output on the amplifier/processor and the other end into the 0dB input on the
sub woofer.
If when using the 0dB input the output of the sub woofer is too low then use the +12dB input.
The output level is adjusted using the control marked LO LEVEL
If the low level connection is to be made to left and right pre-amp outputs then a 12dB
attenuator is available to balance the 0dB and +12dB phono inputs. See below.
Phono to Phono Interconnect.
(Not supplied) To sub/LFE output of
Amplifier/Processor
Sub Low Level
Input
.
Sub Low Level 12dB Phono to phono
Input Attenuator interconnect (Not supplied)