User Manual
11
High Level Input
Connecons should be made to the same binding post on main amplier as the main speakers. Red to
amplier main right speaker red terminal, yellow to amplier main le speaker red terminal and black to
amplier main speaker black terminal, right or le but not both. (See Connecng and seng up secon
below for details on integraon with Class D and Dierenal type amplier designs). Plug the Neutrik®
Speakon® plug into the HI LEVEL Speakon® socket.
.1 Input
This requires an RCA to RCA cable and is a dedicated true .1 channel. This circuit therefore eliminates the
normal Natural RollO™ Crossover and passes the .1 low-level signal through with only the required 120Hz
fourth-order lter.
Low Level Input
The RCA input allows for convenonal connecon from one channel of a preamplier. This connecon is
necessary when using acve, powered speakers or when connecng to certain soundbars. Plug one end of
an RCA to RCA cable into the LOW LEVEL INPUT of the REL and the other end into the le or right channel
output of your preamplier.
Phase Switch
Used to set phase. Phase Switch on remote control is momentary. Refer to display for 0 or 180 degree
status. Phase selecon aects High Level, Low Level and .1/LFE inputs.
PHASE SELECTION AFFECTS BOTH HIGH AND LOW LEVEL INPUTS
Crossover is always engaged for high and low level inputs. The .1/LFE signal does not pass through the
crossover circuit.
Connecvity and Funconality