Installation Guide

ManualsBrandsReliaBilt ManualsBarn Doors8513080BKWL2DS

9851 Series Wall Sliding Door

ILLUSTRATION OF PARTS BREAKDOWN

Installation Instructions

Chaparral –A Division of KLS Doors 501 Kettering Drive, Ontario, CA 91761

ITEM%

NO.

PART%NO. DESCRIPTION QTY.

! "#$! %&'() !

# *"+$ ,--&./'012 !

3 (445637 10,.('/8.219% !

6 (44563" 10,.('/8.&:;4% !

+ (4<5+"

=".>.!5!?#@.A'<41&.41',.<129.

,&:22:0;.<(&1A<

7 (43#5$B75$$$ %-/.&-221&.'<<1CD2E #

B (4<57$

="53#.>.+?!7@.<129.%'//:0;./'0.41',.

<(&1A

" (445667 D-%%-C.;F:,1 !

* (4<566

=753#.>.!5!?6@./'0.41',.<(&1A 6

!$ (445+3$ 2.D&'()1% !

!! (4<56+ =7.<GF'&1.0F% 6

!# (44566$

(Optional*Special*OrderH.4'0,21 #

!3 (4635$!* A&10(4 !

FRAMEWORK:

HARDWARE%BAG:

Summary of content (4 pages)

PAGE 1
9851 Series Wall Sliding Door Installation Instructions ILLUSTRATION OF PARTS BREAKDOWN 11 1 3 11 6 4 9 6 9 5 12 2 7 8 10 5 ITEM% PART%NO. NO. FRAMEWORK: 1 8201 2 9850 HARDWARE%BAG: 3 CHH5436 4 CHH5438 5 6 7 8 9 10 DESCRIPTION QTY. TRACK DOOR.PANEL 1 1 END.CAP,.LEFT END.CAP,.RIGHT #8.X.151/2".WASHER.HEAD.SELF. CHS558 DRILLING.SCREWS CH3250765000 TOP.ROLLER.ASSEMBLY #8532.X.5/16".SELF.TAPPING.PAN.HEAD. CHS560 SCREW CHH5446 BOTTOM.GUIDE CHS544 #6532.X.151/4".PAN.HEAD.SCREW CHH5530 L.
PAGE 2
Wall Sliding Door 9851 Series 1. TOOLS REQUIRED FOR INSTALLATION: Pencil Tape Measure Stud Finder No. 2 Phillips tip screwdriver, Drill w/ No. 2 Phillips tip & 3/16” Metal Drill Bit Wall Anchors (Not Included) Level Roller Bracket Wrench(Included) Safety Goggles (Recommended) IMPORTANT: Before beginning installation, read instructions thoroughly and carefully. Installation may require the need for anchors and/or additional screws that are not included in this package.
PAGE 3
9851 Series Wall Sliding Door 4. 5. O STUDS TRACK T FASTEN HORIZONTAL LINE HORIZONTAL LINE #8 X 1-½ WASHER HEAD SCREW VERTICAL LINE WALL SCORED LINE 3/16 HOLES . A. Place the track in position (top edge of the track on the horizontal line ending at the vertical line). Transfer the stud lines to the track and pre-drill the track along the scored line with a 3/16 drill bit. 6. A. Attach the top track to the wall using #8 x 1-1/2 washer head screws (Item #5). B.
PAGE 4
9851 Series Wall Sliding Door 8. 9. (A) BOTTOM GUIDE EXAMPLE A (B) (C) (D) A. Center the door in front of the bottom guide. B. Insert the top of the door under the track. C. Place the door over the bottom guide. EXAMPLE B D. Lower the door over the bottom guide. 10. 11. ROLLER BRACKET #6 PAN HEADS #6 SQUARE NUT A. Engage the top rollers into the roller brackets at both ends. B.