Installation Guide

A. Place the track in position (top edge of the
track on the horizontal line ending at the
vertical line). Transfer the stud lines to the
track and pre-drill the track along the scored
line with a 3/16 drill bit.
.
VERTICAL LINE
HORIZONTAL LINE
FASTEN TRACK TO STUDS
WALL
HORIZONTAL LINE
#8 X 1-½ WASHER HEAD SCREW
A. Attach the top track to the wall using #8 x 1-1/2
washer head screws (Item #5).
B. If the end of the track does not land on a stud then use
a wall anchor to secure that end.
SCORED LINE
3/16 HOLES
A. Position the L-Bracket (Item #10) on the wall or
baseboard.
B. Align the vertical edge of the L-Bracket with
the vertical edge of the wall as shown and
fasten it the L-Bracket with two #8 X 1-1/2
Washer Head Screws (Item #5).
C. Leave about a 1/8 gap between the floor and
the bottom of the L-Bracket.
A. If the L-Bracket is attached directly to the wall; using a
Phillips head screwdriver attach the bottom guide
(Item #8) to the L-Bracket using two #8-32 x 5/16
Self Tapping Pan Head Screws (Item #7) by inserting
the screws into the holes that are furthest from the
wall. (REFER TO STEP #8 EXAMPLE A)
B. If the L-Bracket is attached to a baseboard use the
holes that are closest to the wall. (REFER TO STEP
8 EXAMPLE B)
REFER TO
NOTE B
REFER TO
NOTE A
4. 5.
6. 7.
9851 Series Wall Sliding Door