Installation Guide

renincorp.com
Step 1. Door Preparation
Note, optional wall- and oor-mounted door guides have
also been provided in this kit should you not wish to
mortise your door.
Mortise 1/4" wide x 3/4" deep groove centrally to the bottom
of the door for use with the oor-mounted door guide. This
will ensure smoothness of door travel side-to-side and will
prevent the door from swinging in and out.
If you prefer, you can also have your door mortised at the store
you have purchased your door (typically, for an additional
charge). See your store for details.
3/4" (19mm)
1/4"
(6.3mm)
Step 3. Door Preparation - Anti-jump block Installation
Position each anti-jump block at least 1" from the edge of the
Straps. Tighten slightly to secure in place.
Step 2. Door Preparation – Strap Installation
Position each strap to the front of the door centre to the stile
or a minimum of 2" from the edge of the door.
Measure or cut a piece of cardboard 2" high and place
between the wheel (inner groove) and the top of the door to
correctly position the height of the straps.
Mark the top hole with a pencil and pre-drill 3/8" holes, then
secure into place. Mark the bottom hole with the strap in place
to ensure the strap is secure. Repeat for second strap.
IMPORTANT: For 1 3/8" Doors, please use the shorter
standard bolts provided.
For 1 3/4" Doors, please use the longer additional bolts
provided.
drill out
3/8" (10mm)
Center to Stile or
minimum of 2" (51 mm)
2" (51 mm)
BD100K-07800 / BD100K-09600 INSTALLATION GUIDE
BARN DOOR HARDWARE STRAIGHT STRAP KIT
2