Installation Guide

renincorp.com
Step 7. DRYWALL Wall Preparation
When installing into drywall, a piece of 81" x 5 1/2" x 7/8" solid
wood blocking is required to be mounted to the wall before
proceeding with the track installation.
Position the solid wood blocking with track by measuring up
from the door height (H) + 1 3/4" to the centre of the track.
This ensures a gap of 3/8" - 1/2" at the bottom. Lastly, ensure
the solid wood blocking is level and leave a minimum of 2"
from the end of the blocking to the side of the opening (as
shown).
If installing with an opening for 80" standard door size, remove
the top trim and cut the side trim horizontally along the height
of the opening.
Paint or stain the wood blocking to your desired nish.
NOTE: The 96" track features an additional hole for wider
door opening sizes. A 97" length piece of solid wood
blocking is required.
Step 8. DRYWALL Wall Preparation
Position the track on top of the wood blocking ensuring
levelness, mark the holes using a pencil and pre-drill
5/16" holes into the wood blocking.
NOTE: The 96" track requires an additional 6th hole to
be drilled.
1 3/8" (30mm)
5/16" (8mm)
Step 9. DRYWALL Track Installation
When installing into the solid wood block and wall, insert
using the provided wall screws. Align each spacer to the track
holes, inserting spacers and screws (with washers), securing
with a wrench.
Ensure to insert both stoppers either side of the track inside
the rst hole.
NOTE: The 96" track features an additional hole for
additional wall spacer and wall screw for drywall
installation.
Door Height + 1 3/4
"
81" (L) X 5 1/2" (H) x 7/8" (D)
78 3/4" (2000mm)
Minimum
2"
(51mm)
3/8" (9.5 mm) –
1/2" (12.7 mm)
Gap under
the door
BD100K-07800 / BD100K-09600 INSTALLATION GUIDE
BARN DOOR HARDWARE STRAIGHT STRAP KIT
4