Full Product Manual

USING THE IRON AS IRONING SYSTEM (FIG. 2)
FILLING THE TANK BEFORE USE
WARNING: Make sure the unit has been disconnected from the power supply
before filling the tank (B) with water.
Before plugging it in, completely unwind the power cord. Rotate the tank lid (C).
Fill the tank with cool tap water (Fig. 7).
NEVER fill the tank beyond the MAX level.
Do not add any additives or chemicals (such as: amides, starches, perfume or
other); otherwise, the warranty may be revoked.
WARNING: To avoid damaging the pump, never operate the appliance without any
water in the tank, even for dry ironing.
Close the tank lid (C).
SWITCHING ON THE APPLIANCE
Place the appliance on a horizontal and stable surface. The power cord (A) and
the iron/boiler connecting cable (P) are coupled to the connections on the cord
storage compartment (X) (Fig. 3). Connect the appliance to the power supply,
ensuring that the voltage indicated on the identification plate corresponds to your
local power supply.
Before you turn on the appliance, make sure there is sufficient water inside of the
tank.
Press the iron power switch (Fig. 10) and set the temperature control knob to the
desired temperature. Press the boiler on-off switch (Fig. 9). When the steam ready
light (R) turns on, the steam is ready.
When first used, the iron may give out a little smoke: This transitory effect is
perfectly normal and will disappear very soon.
Upon first use, after filling the tank, it is necessary to adjust the temperature
control knob (L) over the symbol (•••) and press the steam button (K) Fig. 11 until
the iron does not produce steam (about one minute) Fig. 13. The iron is now ready
for use. Before applying a jet of steam to the article to be ironed, release two or
three good jets of steam towards the floor to stabilize the steam flow.
WARNING: Do not release steam when the iron is standing on its support rest (D).
A decrease in the steam output may occur soon after the pump starts operating:
it is perfectly normal and after a few seconds the steam will be normal. If the iron
has not been used for a long period of time, it is advisable to keep it in a horizontal
position and send a few shots of steam to the floor in order to stabilize the jet
before ironing.
07