Use and Care Manual

STEAM ADJUSTMENT

The appliance is equipped with a regulator (T) that allows the steam output

to be adjusted from a minimum to a maximum setting according to ironing

requirements.

SHOT OF STEAM

For ironing thicker fabrics and for a powerful anti-crease action in vertical

position, it is possible to operate the turbo steam function. Make sure that there

is water in the tank (B) and in the iron tank (M). Place the control knob (T) on

the MAX setting. Wait for the steam ready light (R) to turn on. Set the ironing

temperature by turning the adjustment knob (L) past the symbol (•••). Wait for the

indicator lamp (N) of the iron to turn off. Press the steam button (K) from 3 to 5

seconds.

(Fig. 11). If the steam supply button (K) is operated continuously for more than 30

seconds, drops of water may come from the steam holes in the plate of the iron. It

is recommended that the button (K) be used for shorter periods.

CONTINUOUS STEAM

Turn the steam adjustment knob (T) to MAX. Wait for the steam ready light (R)

to turn on. Set the ironing temperature by turning the adjustment knob (L) past

the symbol (•••). Wait for the indicator lamp (N) of the iron to turn off. When

the temperature has reached, press the steam button (K) Fig. 12. The cursor (J)

will lock the button, allowing the jet of steam to exit continuously. To unlock the

button (K) and stop the continuous jet, press the cursor (J) forward (Fig. 14).

TEMPERATURE SELECTION

First check whether the fabric has a label containing ironing instructions and

compare the symbol with the instructions that follow. If there is no label with

instructions, and you know the type of material, follow the instructions below.

Note that the table refers to fabrics not treated with sizing agents or similar

products; if they have been, you can also iron at a lower temperature.

When you change the temperature by turning the adjustment knob (L), the light

(N) will turn on and stay on until the iron reaches the new temperature.