Use and Care Manual

FILLING THE TANK

Always check the level of water in the tank while you are ironing.

Add enough water to the tank so that the water level is always visible. Do not go

past the MAX level. If the tank remains without water, you will notice a vibration

and loud noise. Turn off the appliance by pressing the switches (S) and (U) and

unplug it from the electrical outlet.

WARNING: Always turn off the appliance and remove the power cable plug from the

outlet before ﬁlling the tank with water.

Add water directly in the tank (Fig. 7). Insert the plug into the electrical outlet and

turn on the appliance again.

If the appliance is not switched off promptly, overheating of the pump could cause

a momentary stoppage of the appliance. Therefore it is necessary to switch off the

appliance and ﬁll the tank. Wait for the appliance to cool down to resume normal

operation.

SPRAY BUTTON

Make sure there is water in the tank of the iron (M). Press the spray button (I). To

enable this feature you may need to press the spray button repeatedly (Fig. 15).

DRY IRONING

To iron dry - i.e. without steam - all you have to do is turn the iron on by pressing

the switch (U) after connecting it to the power supply. Place the steam control

knob to the minimum and adjust the temperature control knob (L) to the desired

temperature. Do not press the steam button.

LABEL IRONING INSTRUCTIONS KIND OF FABRIC

Synthetic fabrics:

Acetate

Acrylic

Viscose

Polyamide (Nylon)

Viscose (Rayon)

Silk

Wool

Cotton

Linen

THERMOSTAT

•

• •

• • •

The mark on the label means do not iron