Use and Care Manual

CLUTCH WASHER/SCREW-ASSEMBLY INSTRUCTIONS

1. Remove clutch stop screw.

2. Remove hand clutch screw.

3. Notice position of prongs on clutch washer in slot of balance wheel bushing.

4. Remove clutch washer and make 1/2 turn and replace.

5. Screw in hand clutch screw very light

6. Screw in stop screw.

7. Back off on hand clutch screw.

8. Run motor and check to see if balance wheel turns freely without running

the machine.

9. Tighten hand clutch screw and the machine should run properly.

BALANCE WHEEL CLUTCH WASHER CLUTCH STOP SCREW

CLUTCH WASHER

PRONGS ON CLUTCH WASHER POINT OUT.

WILL NOT WORK IF POINTED IN.

HAND CLUTCH SCREW

SLOT IN BUSHING