Use and Care Manual

BIG WHEEL
ALLEN SCREW
HANDLE
NEW DRIVEŁ
BELT COVER
5/32" ALLEN KEY
1/8" ALLEN KEY
NEW BELT
7 Install the BIG WHEEL on the
end of the shaft making sure
that the teeth on the wheel are
facing the sowing head.
8 Tighten the BIG WHEEL on the
1/8” Allen key provided.
9 Install the new mail drive belt.
Slip the drive belt over the BIG
WHEEL first and then slip the
belt over the small idle pul-
ley at the back. Turn the small
pulley slowly clockwise to make
sure that the belt is properly in
place.
10 Put back in place the stop
motion screw & clamp motion
washer. Put back in place the
stop motion clamp stop screw.
11 Install the new belt cover on by
two screws.
12 For hand crank operation only,
install the handle to the BIG
WHEEL by tightening the Allen
screw with the 5/32” Allen key
provided.
28