Instruction Manual

600SB SPECIAL INSTRUCTIONS
1
ST
TIME USERS OF BLINDSTITCH MACHINES – PLEASE READ CAREFULLY
If you have never used a blindstitch machine before, it is very important that you read these
instructions carefully.
Failure to read may limit or void the manufacturer’s warranty.
Instructions:
• Activate the knee lifter. This will causes the feed plate to swing downward and create a
gap between the presser foot and the feed plate.
• Insert the work into the gap in such a manner that the folded or sewn edge of the
material is alongside the edge guide of the presser foot.
• When the material is in the proper position, completely release the knee lifter. Run the
machine slowly and watch the material pass the edge guide.
• When you’re done with the seam, to remove the work from the machine, set the looper
in the top forward position (see image below).
Note: Turn the machine (clockwise) only in the direction away from the operator. See the
direction arrow sticker on the machine.
• Activate the knee lifter, this will cause the feed plate to swing downward and create a
gap between the presser foot and the feed plate.
• Pull the work-piece straight back with a quick stroke. This will lock the last stitch
and
break the thread.
• To
start another seam repeat the first three points.
Notes:
The needle must be in 100% good condition at all times, no nicks, blunt point, or bent
needle will work.
When sewing flat seams make sure the work-piece is in deep, under the presser foot, to
allow the needle to penetrate on the first stitch of sewing.
THE LOOPER MUST BE IN THE POSITION AS PER IMAGE TO REMOVE THE WORK
LOOPER IN TOP FORWARD POSITION