Instruction manual

give off steam anymore by shutting the boiler off, and pressing the
steam iron button (7) to release all remaining steam.
• The machine has a special heating element. Only qualified
technician should replace it.
• The safety cap (1) must be replaced with original parts only.
TECHNICAL DATA
Adjustable iron thermostat set from 60°C to 200°C
Bimetallic safety iron thermostat with manual reset at 275°C
Full aluminium-plated heating element at 800W – 230V
Boiler power i500: 1000W
Working pressure i500: 3,5 bar
Tank nominal capacity of model i500: 2.5 litres
TROUBLESHOOTING
PROBLEM
EXPLANATION
SOLUTION
Does
steam go
out from
the boiler?
It may happen that, while filling the
tank, some water overfills the cap
and flows inside the boiler wetting
the insulating material
In order to solve the problem, we suggest
using the machine as usual so that the
insulating material dries up in about one
hour through the heat of the machine. In
case you still have this problem after one
working hour, please contact the service
centre.
Does the
steam iron
leak steam
mixed with
water?
1) While filling the tank you may
have poured too much water into it.
2) The iron plate has to be hot
before the steam passage
1) The problem will go on until the excess
water is emptied. Keep the steam button
depressed until the water in the tank is at
the correct level.
2) Please check that the temperature knob
is on the right position: “cotton °°°)”
There is
no steam
coming out
of the
iron?
1) The steam knob (where
supplied) might be closed
2) The iron switch might be off
3) The boiler switch might be off
4) The water might be used up.
1) Open the steam knob anticlockwise.
2) After the iron switch comes on, wait for 4
minutes so that the iron plate gets hot.
3) After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4) Fill it following the instructions carefully.
Does the
ironing
board get
wet?
1) The ironing board cover might
not be able to absorb the steam
completely
2) The steam iron leaks steam
mixed with water (Check by
spraying some steam on a dry
cloth)
1) You might use a thicker cover (or two
covers) so to create a thicker surface to
absorb the steam better. In case you are
using a vacuum table, switch on the
vacuum function each time you are using
the steam
2) See # 2