User guide

13
IMPORTANT NOTE: Many types of clothing are intricate and unique to their owner.
You may have to experiment with the best way to press challenging garments.
Remember, if you put in a crease you did not intend, you can remove it just as
simply with one of the methods contained in these instructions.
TROUBLE SHOOTING
Below is a chart detailing the most common problems, their causes and solu-
tions. Before shipping any appliance to a service center please check to make
surethatthesolutionisnotlistedhere:
PROBLEM
Steam Press cannot be
opened using the Pressing
Handle.
Steam Press becomes
warmbutDOESNOTremove
wrinkles.
PressDOESNOTgetwarm.
Nosteam
Waterdripsfromthepressing
plate.
The pressing handle will not
move into the automatic
maximum pressure position.
REMEDY
Turn the locking knob to the
unlocked position.
1.Graduallyincreasethe
temperature until obtaining
the desired results.
2.Makeaproperselection.
3. Plug the appliance in.
Pressthe*POWER*button
again.
1.Fillthewatertank.
2. If suitable for the fabric,
make a selection to a
highertemperature.Wait
for the steam ready light to
come on. If not use spray
misting bottle as directed.
Do not press the steam
button more than 5
seconds continuously.
Use lighter pressure on
thicker items. Use added
steam for wrinkles.
POSSIBLECAUSES
The locking knob is in the
locked position.
1. Temperature Setting is not
high enough for the fabric
attempted.
2. Temperature has no tbeen
selected.
3. Press is not plugged in to an
outlet.
AutomaticShut-Offhas
engaged. The Pressing Plate
has been raised for more than
15 minutes without use.
1.WaterLevelistoolow.
2.Controlshavenotbeen
properly set.
Steam button has been
pressed too long.
Item on the Ironing Board is
too thick to use this pressure.