User guide

13. The pressing cushion is a fabric covered pad used for pressing gathered or
contoured areas such as sleeves, darts, and yokes.
14. A plastic water spray bottle is used for dampening fabric before pressing.
15. AwatercontainerisusedforllingtheWaterTank.
The multiple function safety features of this appliance turn off electric power to
the heater when the pressing plate has been left against the ironing board for
about10seconds.Ifthepressingplateisleftintheopen(up)positionwithout
use after approximately 15 minutes, the unit will be automatically shut off. In
eithercase,torestoretheunit,youhavetopressthe*POWER*buttonagain.
Thefollowinginformationisprovidedforservicebyaqualiedelectricianonly:
Ratedvoltage: 120V~,60Hz,1350W
 220-240V,50Hz,1350W
WARNING: This appliance must be grounded. Use only the proper type outlet
when plugging in the appliance. Do not attempt to override the ground wire
feature.
STEAM PRESS OPERATION
STEP 1: PREPARATION FOR USE
Set the steam press on a sturdy work surface. Unlock the locking knob.
STEP 2: FILLING THE WATER TANK
BEFOREPLUGGINGINTHEAPPLIANCE,FILLTHEWATERTANK
a. Always make sure the appliance is unplugged before filling the tank.
b. Fillthewatertankwiththepressingplateliftedtotheraised(up)position.
Slide the water tank towards the front of the unit. It will not come completely
out so do not force it to do so. Using the water container, slowly pour the
water(distilledifavailable)intothewatertankllholes(C).
c. Be careful to avoid spilling water onto the steam press when filling.
d. SlidetheWaterTankbackintoitsrecessedposition.
06