Instruction manual

11
PROBLEM
LED is not on
No steam
Pale residue left on the floor
(caused by leaving the floor
steamer in the same position
for too long)
Too much water on the floor
Sweeper is not working
The brush rotates but no
steam comes out
REMEDY
1. Ensure Steamer power cord is correctly plugged into
power outlet.
2. Ensure circuit breaker is operational.
3. Try operating the steamer from another power outlet.
1. Ensure the water tank has correct level of water.
1. Can be removed with household white vinegar
or a decalcifying product.
2. Alternatively reheat the area for one minute and residue
should be removed. CAUTION: DO NOT OVERHEAT AREA.
1. Hold steam switch for no longer than 5 seconds at a time.
Release the switch for a few seconds and then you can
repeat (the heating element needs time to heat up again to
properly convert the water into steam.
1. Ensure that you have pushed the on/off button (on the base)
to the “on” position.
2. Check the rotating brush/wheel and remove any visible
debris.
3. Remove the small white cap from the base of the unit
beside the brush and check that the belt is in place and free
of debris.
1. Have you pressed the steam release button correctly?
2. The Steamboy T2 is not yet ready to operate. Hold the steam
release button down for approx. 30 seconds until you no
longer hear any pumping noises and the device begins to
emit steam.
3. The water tank is empty. Fill it up.
TROUBLESHOOTING
CAUTION: Prior to troubleshooting isolate the unit by removing the cord
from the power socket.