Instruction manual

• The LED will illuminate when the steamer is connected to power outlet.

Please wait for 20 seconds (heat up period) before pressing the steam

release button. Your Steamboy T2 is now ready for use.

• NOTE: It is recommended that another high wattage appliance is not

operated on the same circuit to avoid a circuit overload.

• Press the sweeper button located on the base to turn the sweeper on/off.

Pass over the area to be swept using a forward motion.

• Slowly pass over surface to be cleaned while pressing the steam release

button to emit steam. Hold the steam switch as you are cleaning for periods of

up to 3-5 seconds only. Holding the steam switch continuously will cause the

unit to release water. It is recommended that you sweep the ﬂoor prior using

the steamer.

CAUTION: To sanitize an area of your ﬂoor, leave the steamer over area for

a minimum of 3 seconds, but no longer than 5 seconds. Leaving the

steamer stationary for a longer period than recommended may cause the

build up of a pale residue. This residue can be removed by using a

decalcifying product or with a few drops of vinegar.

WARNING: Never run the Steamboy T2 without water. Never direct steam at

any person or animal. Use on SEALED HARD FLOOR ONLY.

• When steamer runs out of water it will stop emitting steam. Simply remove

the water tank, reﬁll, and continue cleaning.

• Change the microﬁber pad on the steamer base ocasionally while cleaning to

prevent excess moisture from remaining on the ﬂoor.

• The carpet glide attachment will assist with freshing and sanitizing the

surface of carpets and area rugs. It is not intended to deep clean or lift dirt

from the carpet.

• When you ﬁnish your cleaning, unplug the power cord from outlet, empty the

water tank, carefully remove the pad from steamer head, wind power cord

around the cord wrap

• Carefully pull the dust bin out of the base and empty the contents into a

trash bin. Then place the dust bin back into the unit.

• Over the course of time, hairs, threads and other particles may accumulate

on the rotating sweeper brush. It is advised that these be removed for

optimum functionality.

• Store it upright in a dry area or hang by the storage hook.

CAUTION: The microﬁber pad may be very hot.

NOTE: If you have hard water ensure that the anti-scale cartridge is changed

regularly (at least every six months). Replace it more often if your water is

very hard (ie: well water).