Use and Care Manual

12
PROBLEM
LEDisnoton
Nosteam
Pale residue left on the floor
(causedbyleavingtheoor
steamer in the same position
fortoolong)
Too much water on the floor
Nosteamcomesout
REMEDY
1. EnsureSteamerpowercordiscorrectlypluggedinto
poweroutlet.
2. Ensurecircuitbreakerisoperational.
3. Tryoperatingthesteamerfromanotherpoweroutlet.
1. Ensurethewatertankhascorrectlevelofwater.
1. Canberemovedwithhouseholdwhitevinegar
oradecalcifyingproduct.
2. Alternativelyreheattheareaforoneminuteandresidue
shouldberemoved.CAUTION: DO NOT OVERHEAT AREA.
1. Holdsteamswitchfornolongerthan5secondsatatime.
Release the switch for a few seconds and then you can
repeat(theheatingelementneedstimetoheatupagainto
properlyconvertthewaterintosteam.
1. Haveyoupressedthesteamreleasebuttoncorrectly?
2. TheSteamboyPROT3isnotyetreadytooperate.Holdthe
steamreleasebuttondownforapprox.30secondsuntilyou
nolongerhearanypumpingnoisesandthedevicebeginsto
emitsteam.
3. Thewatertankisempty.Fillitup.
TROUBLESHOOTING
CAUTION: Prior to troubleshooting isolate the unit by removing the cord
from the power socket.