User's Manual

13
In self-programming set, when the basic function is OFF, corresponding settings in the below table can be set, but not
valid.
Self- Programming
(New Functions Setting)
1. Turn on the power while pressing [LAMP] and [○] key, the radio enters the DEALER MODE in 2 seconds.
2. In dealer mode, press [□] key, radio enters “new function set mode”.
3. Rotate the channel selector knob to select the function setting.
4. Press [PTT], the setting is stored and the menu goes to the next function option.
5. Press
[□]
key again, display returns to “SEL” from current function setting, and the setting will not be stored.
6. When setting function options, press [PTT], the settings will be stored and a BEEP sounds to confirm the
operation.
8. End is displayed when all new functions settings are completed.
Function name Settings Disable conditions
2-TONE/ DTMF DTMF 37.DTMF signaling is OFF
2.[SCN] TO 7.Priority is fixed or selected.
6.Priority Fixed, Selected 2.[SCN] is OFF
7.Priority CH 6.Priority is OFF or fixed.
8.Look Back A 6.Priority is OFF
9.Look Back B 6.Priority is OFF
10.Revert CH Priority, Priority + Selected 6.Priority is OFF
11.Dwell Time 2.[SCN] is OFF
12.Dropout Delay Time 2.[SCN] is OFF
14.TOT Pre-Alert 13.Time Out Time is OFF
15.TOT Rekey Time 13.Time Out Time is OFF
16.TOT Reset Time 13.Time Out Time is OFF
31.Connect ID 29.PTT ID is OFF or disconnected and 30. Dial ID is OFF
32.Disconnect ID 29.PTT ID is OFF or connected and 30. Dial ID is OFF.
38.Intermediate Code 37.DTMF/2-TONE signaling is OFF or is code SQ.
40.Unsquelch Time 37.DTMF/2-TONE signaling is OFF.
41.Call Alert/Transpond 37.DTMF/2-TONE signaling is OFF.