User's Manual

17
Note:
1. If DTMF or DTMF/2-Tone is disabled, “ID code” function option is automatically skipped.
2. DTMF and 2-Tone cannot be enabled simultaneously.
Appendix 1: Channel Label Programming
CHARACTER INPUT
Number of times key is pressed
KEY
1 2 3 4 5 6
NUMBER
INPUT REMARKS
1 Spac
e
1
2 A B C 2
3 D E F 3
4 G H I 4
5 J K L 5
6 M N O 6
7 P Q R S 7
8 T U V 8
9 W X Y Z 9
0 A ~ Z 0
A @ # $ % ^ * A
B , . ‘ “ ? : B
C + - \ / = _ C
D < > ( ) [ ] D
* /T9 Press to toggle between Character and Number. “V” on
LCD indicates number input.
# → (Next alphanumeric)
PTT Enter (Complete programming and store channel label)
Channel selector
knob
←, → (Move cursor backward/forward)
Cursor: current input
position will toggle between
char/num and cursor
display.
Each key can generate
numeric and character
information.
Pressing a key will cause
the first character of the
key’s character cycle to
appear on the LCD;
Subsequent pressing of the
same key will cause
subsequent characters in
the cycle to appear. For
example, to enter the
character “S”, press the “7”
key four (4) times.
Wide
WIDE Wide mode
Wideband/Narrowband
Narrow
NARROW Narrow mode
ID
Display about one seconds when entering this setting.
000
-------0
ID is input, enter number→[10 digit keys(0-9)]
ID CODE
(DTMF)
9999999999
9999999999
If more than 8, scroll it
RX 2-TONE
1-16 1
TTS_R 1
2-Tone signaling
TX 2-TONE
1-16 1
TTS_T 1
Code selection→Channel selector knob
Return to “Channel Select” function when 99 channels are
not all set.
When 99 channels are all set, END is displayed.
CH LABEL Display about one seconds when entering this setting.
-------- ------- No channel label is input
Channel Label
POLICE 1 POLICE 1 Maximum 16 characters (0-9,A-Z, symbols)
(Refer to appendix 1: channel label programming)
END
END Only appears in 99
th
channel