User's Manual

19
2. Transmit the clone data by pressing [MONI], red LED glows during data transfer. When data transfer is completed,
“END” is displayed on LCD, and the red LED turns off.
3.
When “End” is displayed, press [MONI] button to continue to clone another radio or press [LAMP] to return to Dealer
Mode.
Target radio
Operation
1. Turn On the power. When data is being sent from the master, busy mark and "-PC-" appears on LCD.
2. When all data is received, “END” displays on LCD.
After the “END” appears, operation is same as the source radio operation 3.
Note:
During cloning, do not execute any action that might interrupt the cloning such as shutting off power.
Wireless Clone Mode
Setup the source side and target side.
Source Side
Operation
1. Turn POWER ON while holding down [LAMP] and
[
○
]
key
, in about 2 seconds radio enters the Dealer Mode. Then
press [MONI], radio enters Wireless Clone Mode, now the frequency displayed on LCD is the initial frequency
matching the destination.
Clone ModeDealer Mode
[LAMP]
Sending clone data Red LED on clone data transfer end Red LED off
Dealer Mode
[MONI]