User's Manual

23
3.
Connect the source radio and the target radio with an interface cable.
4. Turn the target radio on.
5.
Now press [
□
] key to enter Adjustment Data Clone Mode. LCD displays “–C–“.
6. Press [MONI] key to transmit the adjustment data.
7.
Red LED glows during data transfer. When data transfer is completed, “END” is displayed on LCD and red LED
turns off.
8. When “End” is displayed, press [MONI] to continue to clone another radio.
9. Press [
■
] key to exit from Adjustment Data Clone Mode. LCD displays “TUNE CLN”.
Destination Set Mode
Operation
1. Turn the power ON while pressing [LAMP] and [
■
] key, in about 2 seconds the radio enters the menu of Test Mode.
2. Turn Channel Selector knob to select the setting option “DEST SET”.
3. Now press [
□
] key to enter Destination Set Mode, LCD displays “ MODEL X“. (X=0~15)
4. Turn Channel Selector knob to change the destination number. (Display numbers change from 0 to 15).
5. Hold down [MONI] key and then press [
□
] key to select the display number that you need as the destination.
6. Press [LAMP] key to reverse CDCSS decoder and LCD displays “V”. (For factory setting only).
7. Press [
■
] key to exit from Destination Set Mode. LCD displays “DEST SET”.
Note:
[ ¡ ö ]
Test Mode
Destination on dispiay is stored in the memory
[Channel Selector]
Destination Set Mode
Destination Set Mode
[PTT]
[ ¡ õ ]
[
MONI
]
+
[
□
]