User's Manual

24
1. Once the destination is set, previous channel settings (frequencies, CTCSS and channel functions) will be deleted and
some functions are also changed. Therefore, do not make destination set except when EEPROM is replaced or other
unavoidable conditions happened.
2. Destination of RPV599APlus is set as 8, frequency is 148~174MHz. And destination of RPU499APlus is 11,
frequency 450-470MHz.
Frequency Test Mode (for frequencies checking and radios repairing)
Operation
1. Turn POWER ON while pressing [LAMP] and [
■
] key, in about 2 seconds the radio enters the menu of Test Mode.
2. Turn Channel Selector knob to select the setting option “FREQ TST”.
3. Press [
□
] key to enter Frequency Display Mode. LCD displays frequency.
4. Turn Channel Selector knob to increase/decrease the frequency.
5. Press [
○
] key to switch the step increments.
6. Press [
□
] key to toggle between High and Low Power.
7. Press [
●
] key, the radio enters scan mode.
8. Press [PTT] to transmit and [MONI] to monitor.
9. Hold down [LAMP] and then press [
○
] key, the radio enters CTCSS set mode.
10. Press [
■
] key to exit from Frequency Display Mode, LCD displays “FREQ TST”.
Notes:
1. The reset (initial) frequency varies according to the destination.
2. Set initial transmit power to LO POWER.
Changing the Frequency
Operation
1. In Frequency Test Mode, turn Channel Selector knob clockwise, the frequency increases in step increments. Turn the
knob counterclockwise, the frequency decreases in step increments.
2. Hold down the [LAMP] key, and then turn the Channel Selector knob to change the frequency in 1MHz step
increments.
3. Press [
○
] key, the step increment is switched in the following order.
Frequency Display Mode
[ ¡ ö ]
[ ¡ õ ]
Test Mode