User's Manual

7
2. Description of Mode Functions
3. Keypad Entry for Mode Startup
MODE FUNCTION
USER MODE
Conventional mode
DEALER MODE
Dealer set the below modes:
Function set mode, DTMF set mode, Channel set mode, Wired clone mode, Wireless clone
mode, All Reset
Self Programming
(FUNCTION SET MODE)
The dealer set the following functions ON/OFF according to the user operating needs.
1.Monitor 2.Scan 3.Dial 4. Talk around 5.Low 6.Priority 7.Priority Channel 8.Look Back A
9.Look Back B 10.Revert Channel 11.TX Dwell time 12.Dropout Delay Time 13.Time out
Timer 14.Tramsmit Warning 15.TOT Rekey Time 16.TOT Reset Time 17.Squelch Level
18.BEEP 19.Signalling 20.Battery Save 21.Selectable CTCSS 22.DELETE/ADD
23.Dealer Mode-Test Mode
Self Programming
(DTMF SET MODE)
The dealer set the following functions ON/OFF according to the user operating needs.
24.Digit Time 25.Inter Digit Time 26.First Digit Time 27.Rise Time 28.Rise Time with
CTCSS 29.PTT ID 30.Dial ID 31.Connect ID 32.Disconnect ID 33. NO. of DTMF key
34.DTMF Hold Time 35.Store & Send 36.D key Assignment 37.DTMF Signaling
38.Intermediate Code 39.Group Code 40 SQ. Auto Reset Time
41.Call Alert/ Transpond
Self Programming
(CHANNEL SET MODE)
The dealers use this mode to set channel frequencies and signaling according to the user
operating needs.
1.Channel Selection 2.RX Frequency 3.RX Signaling 4.TX Frequency 5.TX Signaling
6.DTMF/2-Tone signaling 7.PTT ID Enable 8.Scan DEL/ADD 9.Busy Channel Lockout
10.Clock Frequency Shift 11.TX Power 12.Wide/narrow Band
13. ID Code/RX 2-Tone 14. TX 2-Tone 15. Channel Label
Self Programming
(NEW FUNCTION MODE)
45.group tone 46. group tone duration 47. channel label size
48. programmable key 1
[
●
] 49.
programmable key 2
[
○
]
50.
programmable key 3
[
■
] 51. p
rogrammable key 4
[
□
]
WIRED CLONE MODE In this mode data is copied from one radio to another through a cable.
WIRELESS CLONE MODE In this mode data is copied from one radio to another without cable by means of the DTMF
signal.
ALL RESET In this mode transmit/receive frequencies of each channel and function settings are
initialized.
MENU MODE This mode is used to enter the following setting options.
ADJUSTMENT
MODE
This mode is for alignment of radio operation.
FREQUENCY
TEST MODE
This mode is for checking the frequencies and repairing the radio.
ADJUSTMENT
DATA CLONE
MODE
This mode is used to clone adjustment data from one radio to another.
LCD FULL SCREEN
MODE
All characters and signs on the LCD are displayed.
TEST
MODE
DESTINATION SET
MODE
This mode sets radio destination.