User's Manual

PRELIMINARY
PRELIMINARY PRELIMINARY
PRELIMINARY –
––
– Service
ServiceService
Service Manual
Manual Manual
Manual
DR• CHKD• APPD•
36
（
12
）
Reset scan mode
（
13
）
Scan priority
3． PC modify mode•
Make settings through external programmer or PC program software:
（
1
）
Frequency stability
（
2
）
RF power
（
3
）
Low power alarm
（4） Squelch•level 9&3•
（5） CTCSS deviation•Wide/Narrow••
（
6
）
DQT deviation
•W
ide/Narrow
••
（
7
）
Receive sensitivity•low•medium•high•
4． Wire Clone:
Press MONI to turn on the power , enter wire clone mode 2 seconds
later, press PTT,
Begin cloning while red lights, finish while light goes out.
5． Mode setting:
•
Short cut the SELF on PCB, and turn on the power till “BEEP”.
• Set channel selector knob to corresponding place according to
the model•1-16•
• Press [MONI]•then press [PTT], to set the channel, channel data and
initial data.
•
Turn off the power, disconnect SELF on PCB to end mode settings.
Eg. RPV516A•2•, its serial number is 2, to initialize: short cut SELF on
PCB to turn on
The power, set channel selector knob at CH2, press MONI, then press
PTT, the initial data of 1-4 channel can be found in the diagram,
serial number 2. Reset data to initial data. The receive and transmit
frequency of channel 5-14 are the same with channel 1, signals are
channel5, 10•67.0Hz•6,11•151.4Hz•7,12•250.3Hz•8,13•423•DQT••9,14•-
423•DQT•, Channel 1-9 are Wide , Channel 10-14 are Narrow•Turn off
the power after reset, disconnecting SELF and restart the power to
use the transceiver.
• Remarks:
The old data(frequency, CTCSS/DQT, channel function) will be deleted once set the new
mode by pressing MONI AND PTT , part of the function also would be changed. Therefore,
do not set this operation unless change the EEPROM, etc.