User's Manual

PRELIMINARY
PRELIMINARY PRELIMINARY
PRELIMINARY –
––
– Service Manual
Service ManualService Manual
Service Manual
DR• CHKD• APPD•
39
6． Manual Modify Mode•
Press PTT and MONI simultaneously to turn on the power•enter manual modify
mode out 3 seconds later. Choose the settings by turning the channel selector
knob 1-12CH, use PTT•upward•or MONI•downward•to modify•Notice: MIC
shouldn’t be connected with external cable while modifying•,1~12CH are
defined as follows:
（1） Frequency stability
（2） RF power
（3） Low power alarm
（4） Receiver sensitivity•IF point modify）
（5） Receiver sensitivity•low point modify）
（6） Receiver sensitivity (high point modify)
（7） Squelch• level 9•
（8） Squelch•level 3•
（9） CTCSS deviation•Wide•
（10） CTCSS deviation•Narrow•
（11） DQT deviation•Wide•
（12） DQT deviation•Narrow•
13~16CH are used for adjusting transmitter and receiver. Press PTT to transmit;
Press MONI to choose: Wide/Narrow•one Beep sound is Narrow•two Beep
sound is Wide. 13~16CH are defined as follows:
（13） IF frequency (discrepancy of transmission and receive frequency
is 0.1MHz).
（14） Lowest frequency (discrepancy of transmission and receive
frequency is 0.1MHz).
（15） Highest frequency (discrepancy of transmission and receive
frequency is -0.075MHz)•
（16） IF frequency•sends 250.3Hz CTCSS signals (discrepancy of
transmission and receive frequency is 0.1MHz).
Notice:To enter and shut off manual modify mode by short cut the SELF. Turn on the
power, and enter settings mode, the manual function is automatically on. Press [PTT]
to disable manual modify. Once this function is disabled, this mode is not accessible,
kindly suggest disable this mode after modifying.
••CPU•
CPU control M38034M4