User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
33
Aurora User’s Manual
You can change the attributes of the following functions by
pressing keys as described below:
Backlite
1. Press [E]nter to start the timeout value
to flash.
2. Press [E]nter. The existing number will
flash.
3. Press [0]–[6] to set the time to off (0)
or for 1-6 seconds.
4. Press
or
to change the timeout
value by 0.1 second.
5. Press the [E]nter key to exit the
backlite editing mode. Press [H]ome to
exit function menu.
Priority Channel
You can only select priority channel mode
when the radio is in Mode C or D.
Press the [E]nter key to make the value
change to the channel knob assignment.
Radio Page
This function displays the page type
(DTMF or 5 Tone) and then displays the
last-called number, if any. (These numbers
can only call other radios. Don’t give your
cell phone away.)
1. Press any key [0]–[9] to clear the
display.
The key you just pressed and subsequent
keys are displayed, up to 10 digits.
2. Press PTT when a radio page number
has been entered. After the page has
been sent, the radio exits the function
menu.