User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
35
Aurora User’s Manual
Editing Frequently Called Numbers
To edit a frequently called number, press
[E]nter when the display shows the
attribute for the currently selected number.
You can use the following valid keys to
edit a
frequently called number
attribute:
• [H]ome. Clears the number or alpha.
Type attribute has no effect.
• . In edit mode, the down arrow key
shifts the cursor to the right.
• . In edit mode, the up arrow key
shifts the cursor to the left.
• Any key. When you press any key
more than once, the radio will display
the character set for that key based on
the number or alpha attribute you
selected.
Pressing the same key more than once
also lets you move the cursor when
you are editing a number and/or alpha
character.