User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
41
Aurora User’s Manual
For advanced radios in manual mode, you
can use the keypad for the following six
functions:
1. Reassign the variable guard.
Press number keys [0] through [9]
2. Enter group change mode:
Press the [H]ome key. Then press
or
to change the group number.
3. Add or delete channels from the scan
list.
Press the [E]nter key.
4. Review a channel’s Code Guard
assignment.
Press and hold the [
*
] key.
5. Enter the function menu.
Press either
or
.
6. Lock or unlock the keypad.
Press and hold the [#] key for 1
second.
If priority channel operation is activated in
manual mode, the radio will monitor, not
only the selected manual channel, but also
the group priority channel at the priority
sampling rate.
Tone/Monitor Toggle
From the function menu, you can toggle
tone mode and monitor mode:
1. Tone mode—Listening to channels
only if the correct Code Guard or radio
paging code programmed for that
channel is present.
2. Monitor mode—Listening to channels
regardless of the channel Code Guard
or radio paging code programming.
R114.8 T107.2
Code Guard
Assignment
Channel 1
Keypad Locked