User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
48
BK Radio
Priority Scan
Priority Scan with Code Guard
Priority scan can be used along with Code
Guard when:
• You move the three-position switch into
position 1, which displays the channel
frequency.
• You press the top, gray button on the side
of the radio to toggle to the Code Guard
position
• You press the middle button on the side
of the radio to toggle to the priority
position
• The priority channel is programmed with
Code Guard
If a message is received on the priority
channel, the radio receiver locks on to the
priority channel for the duration of the signal.
You will only hear the message if the proper
Code Guard value is received. The radio
resumes scanning after the message ends and
the scan delay time expires.
PRIORITY MODES
The Aurora radio has five priority channel
modes of operation as shown in Table 6.
Your dealer can program these modes by
group, which lets the radio receive on any
channel while monitoring for messages on the
designated priority channel. The priority
sampling rate can be programmed by your
dealer for between 0.25 and 2.50 seconds,
regardless of activity on any other channel.
.
..
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
Code
Guard
Priority