User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
60
BK Radio
Call page or FCN sequences are
transmitted after you
1. Select the CALL feature or one of the
FCNs from the function menu
2. Press the PTT switch
The page/FCN of your radio is transmitted
on the appropriate channel depending on
the manual/scan/priority mode of your
radio and the carrier activity when you
press the PTT switch. If the transmit
channel has Transmit-ANI assigned, the
leading/trailing/or both Transmit-ANIs are
sent as normal. The radio uses either the
DTMF or 5-Tone ANI assigned to the
channel. The call page/FCN goes out after
the leading ANI and before the trailing
ANI. Independent of whether DTMF or 5-
tone was assigned to the Transmit-ANI
channel, the call page/FCN goes out using
the DTMF or 5-Tone ANI you specified
when defining the call page or FCN.
Note: Call pages/FCNs using
DTMF digits “*” and “#” might
yield unpredictable results when
used within 5-Tone systems.
The Aurora radio can be factory enabled
so you can access radio paging from the
function menu. When enabled, the radio
paging operation is able to transmit the
FCN list of call pages.