User Manual

16 BK Radio
3. Press [PRI] to toggle the function on/off
when the desired menu item is displayed.
When the display flashes, the function is
enabled.
KEYPAD LOCK
To lock/unlock the keypad, press and hold the
[FCN] key.
LOCKOUT EXCEPTIONS:
1. If enabled, a long [PRI] key press will
activate Emergency Mode even when the
keypad is locked.
2. PTT unlocks the keypad during transmit
for DTMF key presses if the radio is
programmed for DTMF operation.
3. The keypad will be automatically unlocked
when Unit-To-Unit Mode is entered by
pressing PTT to respond to a Unit-To-Unit
call, when Unit-To-Unit callback is
enabled. The keypad will be re-locked
when Unit-To-Unit Mode is exited.
SCAN OPERATION
1. Slide Switch B (SCAN) up.
2. Slide Switch C (priority) down.
The display indicates scan operation by
flashing
SCN or two flashing dashes at the
right side of the display if Numeric Display
Mode is selected.
Scan operates only while the radio is not
transmitting. The radio checks for signals on
channels in the preset Scan List, as well as
the channel selected by the Channel Selector
knob.
When a signal is detected, scanning stops and
the message is received. The received
channel is shown in place of the transmit
channel.
SCN
LABE
L
3
c
h
1
- -
DPH Owner’s Manual 29
1. Press the [#] key to toggle a decimal on or
off to the right of the character in position
7. The decimal moves left with the number
in position 7 as new numbers are entered.
2. Use the following steps to enter a number
in position 8 or characters in positions 1-8:
a. Press the [PRI] key repeatedly to
cycle through characters 0-9, A-Z, -, *,
$, /, +, %, \, |, _, <, >, h, blank, then
back to the start again.
If you pass the desired character,
press the [PRI] key repeatedly until
you return to the start and reach that
character again.
b. Press the [FCN] key to shift the
display left by one position, leaving
position 8 blank.
c. Press the [PRI] key repeatedly to
enter the next character, or press the
[FCN] key a second time to enter a
blank space.
d. To abandon changes, press the [CLR]
key, restoring the original label.
e. Press the [ENT] key to store changes.
PROGRAMMING A NUMERIC ID
Press [ENT] to display the numeric ID. Press
[CLR] then enter the new ID (up to 7 digits).
Press [ENT] to store the new ID. Select a
new ID to be programmed, or press and hold
[ENT] to exit Programming Mode (the PRG
annunciator will be extinguished).
PRG ID
14
5